![]() ![]() Such sections shall be designed in accordance withthe requirements of ASME B16.34.Ĥ.2.2When a wafer-type valve is installed between pipingflanges and the disc is in the closed position, the valve shallbe self-centering, that is, designed to center itself within thebolt circle by using the valve’s outside diameter, or by meansof integral or attached alignment devices.Ĥ.2.3 End flanges for double flanged valves shall be inte-grally cast or forged with the body however, flanges may bcattached by full-penetration butt welding if agreed to by thepurchaser. Shaft-to-lever connections shall be designed so that thelever always correctly indicates the disc position.Ĥ.2.1 The minimum body-wall thickness shall comply withthe applicable ASME Bl6 standard listed in Section 2 basedon the body material.If the applicable standard covers fittingsfor a particular material, the valve minimum wall thicknessshall be as specified for fittings.The valve design shall bestructurally suitable for its stated pressure and temperaturelimits, taking into account that localized thinning may be nec-essary between the shaft bore in the body and thc adjacentbolt holes. The indication of the position of the disc shall be integralwith the valve shaft.The indication may be accomplished bya mark on the shaft or by a shaft shape.The design shallensure that a valve (andor operator) cannot be assembled tofalsely indicate the valve’s open and closed positions. Provisions for a lockable device are permitted even when it is not specified in thepurchase order. ( 100 mm) long, can be inserted directlythrough appropriate holes and locked. ![]() ![]() When specified in the purchase order, valves shall be fur-nished with a lockable device that accepts a purchaser-sup-plied lock that enables the valve to be locked in both the openand closed positions.The lockable device shall be designedsuch that a lock with a 5/16-in. Supporting docu-mentation shall be made available to the purchaser uponrequest. If the purchaser specifies fire tested valves, the valves shallbe certified to have been tested to, and met, all of the perfor-mance requirements of API Standard 607. In the eventof a conflict between ASME B16.34 and this standard, thisstandard shall prevail. Valves manufactured in accordance with this standard shallmeet the requirements of ASME B16.34 for standard classand any additional requirements as specified in this standard.For materials not listed in B16.34,the applicable require-ments and design rules of B16.34 shall be used. Temperaturelimits shall be marked on the nameplate as required in 7.1.Ī valve’s differential pressure rating measures the valvescapability to hold pressure from one side either at shutoff orin the partly open position with flow in the line. #API 609 CATEGORY B PDF PDF#API 609 pdf download Butterfly Valves: Double Flanged, Lug- and Wafer-Typeģ.3.1For Category B valves the valve seat ratings for PTFEand RPTFE shall be at least equal to those listed in Table 3.For seating materials not listed in Table 3, seat ratings shall bcagreed upon by the purchaser and the manufacturer.ģ.3.2Valves furnished with internal liners, encapsulation,resilient seating materials,or a combination of these featuresshall have pressure-temperature limits conforming to thevalve manufacturer’s published specifications. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |